A grill that wouldn’t light, wired to a power supply that wasn’t DCS
October 2026 · Westwood, Los Angeles- Diagnosed
- Written estimate
- Repair: not done yet
It is a 36-inch built-in natural-gas grill; the rating label reads BE1-36RC-L. Before anyone bought igniters, our technician looked at what was powering them. The grill’s original power cord had been cut and tied into an aftermarket power supply. Several conductors in the grill’s own wire harness had been cut too, and joined back together with wire nuts. A separate transformer and a third-party 12-volt LED driver sat loose on a shelf in the cabinet underneath.




On that power, the lights, the LED bezel, the igniters and the switches could not be tested, so nobody could yet say whether any of them was bad. Our technician’s findings put the wiring first: it has to be put back to the manufacturer’s specification, with the correct OEM power supply or transformer installed, before anything else can be tested. Only after that can the igniters and bezel be checked, and the final parts list waits for that test.
Paid so far: the $85 diagnostic. As of this writing, the repair itself hasn’t been done.




